| 1. |
With the washer motor connected to the
reservoir tank, fill the reservoir tank with water.
|
Before filling the reservoir tank with
water, check the filter for foreign material or contamination.
if necessary, clean the
filter. | |
| 2. |
Connect positive (+) battery cables to
terminal 1 and negative (-) battery cables to terminal 2
respectively. |
| 3. |
Check that the motor operates normally and
the washer motor runs and water sprays from the front
nozzles. |
| 4. |
If they are abnormal, replace the washer
motor.
[Front & Rear washer]
1. Ground
2. Windshield washer (+)
3. Rear washer (+)
|
Washer
Fluid Level Sensor Switch
| 1. |
Disconnect the negative(-) battery
terminal. |
| 2. |
Drain the washer fluid less than 950
cc. |
| 3. |
Check for continuity between the No. 1 and
No.2 terminal in each float position.
There should be continuity when the float is
down.
There should be no continity when the folat
is up. |
| 4. |
If the continuity is not as specified,
replace the washer fluid level switch
|
| -
|
When servicing the washer pump, be
careful not to damage the washer pump
seal. |
| -
|
Do not operate the washer pump before
filling the washer reservoir.
Failure to do so could result in
premature pump
failure. | |
| 1. |
Disconnect the negative (-) battery
terminal. |
| 2. |
Remove the front bumper cover. (Refer to
Body group - Front bumper) |
| 3. |
Remove the washer hose and the washer motor
connector(A).
|
| 4. |
Disconnect the washer fluid level sensor
switch connector (A).
|
| 5. |
Remove the washer reservoir after removing 3
bolts.
|
| 1. |
Reassemble the washer
reservoir.
|
Before installing the pump motor,
check the filter for foreign material or contamination. if
necessary, clean the filter into the pump
motor. | |
| 2. |
Connect the washer motor connector and
washer hose. |
| 3. |
Reassemble the front bumper
cover. |
