Inspection

1.	Check the power tailgate control module input/output value by using the diagnostic tool. If the operation of tailgate control module is abnormal, replace anti pinch strip control module.

2.	When checking the anti pinch strip operation, select a vehicle type and "POWER TAILGATE" menu.

3.	Select the "CURRENT DATA". And then check the anti pinch strip sensor output while operating power tailgate in power mode. ※ Above voltage and numerical value may be different from the real value.

4.	Change the anti pinch strip sensor, if there is no change from OFF to ON during operation.

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the tailgate trim. (Refer to the BD group - "Tailgate")

3.	Remove the anti-pinch strip sensor connector (A).

4.	Remove the left and right side anti-pinch strip sensor (A) after removing the screws (4EA).

Installation

1.	Reassemble the left and right side anti-pinch strip sensor using the screws.

2.	Connect the anti-pinch strip sensor connector.

3.	Reassemble the tailgate trim.