| 1. |
Remove the ignition key from the
vehicle. |
| 2. |
Disconnect the battery negative cable and
wait for at least three minutes before beginning
work. |
| 3. |
Disconnect the DAB, PAB, SAB, CAB and BPT
connectors. |
| 4. |
Remove the floor console and heater ducts.
(Refer to BD group) |
| 5. |
Pull the lock(1) forward and the pull the
lever(3) after presing the lever lock(2).
Disconnect the SRSCM connector (A) and
(B).
|
| 6. |
Remove the SRSCM mounting bolts(3EA) from
the SRSCM, then remove the SRSCM. |
| 1. |
Remove the ignition key from the
vehicle. |
| 2. |
Disconnect the battery negative cable and
wait for at least three minutes before beginning
work. |
| 3. |
Install the SRSCM with the SRSCM mounting
bolts.
Tightening
torque (SRSCM Mounting bolt)
: 8 ~ 12 N.m (0.8 ~ 1.2 kgf.m, 5.9 ~
8.9 lb-ft)
|
|
Use new mounting bolts when replacing
the SRSCM after a
collision. | |
| 4. |
Connect the SRSCM harness
connector. |
| 5. |
Install the heater ducts and floor console.
(Refer to BD
group) |
| 6. |
Connect the DAB, PAB, SAB, CAB and BPT
connectors. |
| 7. |
Reconnect the battery negative
cable. |
| 8. |
After installing the SRSCM, confirm proper
system operation:
| A. |
Turn the ignition switch ON; the SRS
indicator light should be turned on for about six seconds and
then go
off. | | |
