VERACRUZ(EN) >2011 > G 3.8 DOHC > Fuel System > Engine Control System > Accelerator Position Sensor (APS)>Repair procedures
Component Inspection
1.
Connect a scan tool to the Diagnosis Link Connector (DLC).
2.
Start engine and check output voltages of APS 1 and 2 at C.T and W.O.T.
Specification:
Refer to SPECIFICATION.
3.
Turn ignition switch OFF and disconnect the scantool from the DLC.
4.
Disconnect APS connector and measure resistance between APS terminals 4 and 5 (APS 1).
Specification:
Refer to SPECIFICATION.
5.
Disconnect APS connector and measure resistance between APS terminals 1 and 6 (APS 2).
Specification:
Refer to SPECIFICATION.
