| 1. |
Disconnect the battery negative cable and wait
for at least 3 minutes before beginning
work. |
| 2. |
Remove the following parts. (Refer to BD
group)
| A. |
Rear Seat, Luggage side
trim |
| B. |
Rear pillar trim, Room
trim | |
| 3. |
Disconnect the Curtain Airbag harness
connector.
|
| 4. |
After loosening the mounting bolts and nuts
remove the curtain airbag.
|
| 1. |
Remove the ignition key from the
vehicle. |
| 2. |
Disconnect the battery negative cable and wait
for at least three minutes. |
| 3. |
Install a Curtain Airbag (CAB) on the mounting
bracket. |
| 4. |
Tighten the CAB mounting bolts and
nuts.
Tightening
torque
: 1.1 ~ 1.5 kgf.m(10.8 ~ 14.7 Nm, 8.0 ~
10.8 lb.ft)
|
| •
|
Never twist the airbag module when
installing it. If the module is twisted, airbag module
may operate
abnormally. | | |
| 5. |
Connect the CAB
connector. |
| 6. |
Install the following parts. (Refer to BD
group)
| A. |
Roof trim, Rear pillar
trim |
| B. |
Luggage side trim, Rear
seat | |
| 7. |
Reconnect the battery negative
cable. |
| 8. |
After installing the Curtain Airbag (CAB),
confirm proper system operation:
| A. |
Turn the ignition switch ON; the SRS
indicator light should be turned on for about six seconds and
then go
off. | | |
