| 1. |
Remove the shift lever knob (A).
|
| 2. |
Remove the center console cover
(A).
|
| 3. |
Remove the center console. (refer to Console
in BD group) |
| 4. |
Remove the shift cable assembly (C) by
removing the clamp (A) and the snap pin (B).
|
| 5. |
Disconnect the interlock switch connector
(A).
|
| 6. |
Remove the shift lever assembly
(A).
|
| 7. |
Remove the retainer (A) and nuts
(B).
|
In case, remove the crash pad and cowl
cross bar. (refer to Crash pad in BD group and Heater unit in
HA group) | |
| 8. |
Remove the shift cable assembly from the
transaxle. (refer to Automatic transaxle's
removal) |
| 9. |
Remove the shift cable
assembly. |
| 1. |
Install the retainer (A) and nuts
(B).
Tightening
torque :
12-15Nm (1.2-1.5kgf.m,
8.7-10.8Ib-ft)
|
|
In case, install the crash pad and cowl
cross bar. (refer to Crash pad in BD group and Heater unit in
HA group) | |
| 2. |
Install the shift lever assembly
(A).
Tightening
torque :
9-14Nm (0.9-1.4kgf.m,
6.5-10.1Ib-ft)
|
|
| 3. |
Connect the interlock switch connector
(A).
|
| 4. |
Install the shift cable assembly (C) by
installing the clamp (A) and the snap pin (B).
|
| 5. |
Install the center console. (refer to Console
in BD group) |
| 6. |
Install the center console cover
(A).
|
| 7. |
Install the shift lever knob (A).
|
Before completing installation, adjust
the shift cable referring to ADJUSTMENT
section. | |
| 8. |
Install the shift cable assembly to transaxle.
(refer to Automatic transaxle's
installation) |
| Adjusting The Shift
Cable |
| 1. |
Set the room side lever and the manual lever
to "N" position. |
| 2. |
Push the shift cable lightly to "F" direction
shown to eliminate the free play.
|
| 3. |
Tighten the adjusting nut (A).
Tightening
torque :
8-12Nm (0.8-1.2kgf.m,
5.8-8.7lb-ft)
| |
| 4. |
Check that this part operates surely at each
range of the manual lever corresponding to each position of the room
lever. | |
