Rear Wiper And Nozzel
| 1. |
Install the rear wiper arm and blade to the
specified position.
Specified
position
|
A
|
Distance
|
1.417
± 0.2 in (36 ± 5 mm)
|
※ Specified position : The first deicer line
from bottom of the rear window.
|
| 2. |
Set the rear washer nozzle on the specified
spray position.
|
Rear Wiper Motor
| 1. |
Remove the 4P connector from the rear wiper
motor. |
| 2. |
Connect battery positive (+) and negative (-)
cables to terminals 3 and 4
respectively. |
| 3. |
Check that the motor operates normally.
Replace the motor if it operates abnormally.
|
Automatic Stop Operation Check
| 1. |
Operate the motor at low speed using the stalk
control. |
| 2. |
Stop the motor operation anywhere except at
the off position by disconnecting terminal
3. |
| 3. |
Connect terminals 2 and
3. |
| 4. |
Connect the positive (+) lead from the battery
to terminal 1 and the negative (-) lead to terminal
4. |
| 5. |
Check that the motor stops running at the off
position.
|
| 1. |
Detach the wiper cap, then remove the rear
wiper arm (A) after removing a nut (B).
|
| 2. |
Remove the rear wiper cap & pad (B) after
removing a HEX nut (A).
|
| 3. |
Open the tailgate glass then remove the
tailgate trim. |
| 4. |
Disconnect the rear wiper motor connector then
remove the rear wiper motor (A) after removing 2 bolts.
|
| 1. |
Reassemble the rear wiper motor
assembly.
Tightening
torque Nut :
14~17 Nm (1.4~1.7 kgf.m, 10.1~12.3
lbf.ft)
| |
| 2. |
Reassemble the tailgate
trim. |
| 3. |
Reassemble the HEX nut and the rear wiper cap
& pad.
Tightening
torque Nut (A) :
10~13 Nm (1.0~1.3 kgf.m, 7.2~9.4
lbf.ft)
| |
| 4. |
Reassemble the rear wiper arm and rear wiper
cap.
Tightening
torque Nut(B) :
14~17 Nm (1.4~1.7 kgf.m, 10.1~12.3
lbf.ft)
| |
