| 1. |
Check that the red light flickers when the
door lock or unlock button is pressed on the
transmitter. |
| 2. |
Remove the battery and check voltage if the
red light doesn't flicker.
|
| 3. |
Replace the transmitter battery with a new
one, if voltage is below 3V then try to lock and unlock the doors
with the transmitter by pressing the lock or unlock button five or
six times. |
| 4. |
If the doors lock and unlock, the transmitter
is O.K, but if the doors don't lock and unlock, register the
transmitter code, then try to lock and unlock the
doors. |
| 5. |
If the transmitter is failure, replace only
the transmitter (A). |
| Transmitter Code
Registration |
| 1. |
Connect the DLC cable of scan tool to the data
link connector (16 pins) in driver side crash pad lower panel, turn
the power on scan tool.
|
| 2. |
Select the vehicle model and then do "CODE
SAVING".
|
| 3. |
After selecting "CODE SAVING" menu, push
"ENTER" key, then the screen will be shown as below.
|
| 4. |
After removing the ignition key from key
cylinder, push "ENTER" key to proceed to the next mode for code
saving. Follow steps 1 to 4 and then code saving is
completed.
| |
