| 1. |
Remove the TCU. (refer to TCM's
Removal)
|
Do not touch the
terminals. | |
| 2. |
Drain the oil by removing the overflow plug
and the O-ring using a torx wrench (T40), and the drain plug (A) and
the gasket by using a hexagon wrench (17mm).
|
| 3. |
Disconnect the oil cooler hoses from the
tubes. |
| 4. |
Remove the 2 bolts to remove the oil cooler
tubes (A) and the O-rings.
|
| 5. |
Remove the transaxle side cover and the
valve body assembly. (refer to Solenoid valve's
Removal))
|
Be careful not to drop the valve body
assembly. | |
| 6. |
After removing the wire lock plate (A),
remove the wire (B) from the transaxle case.
| • |
Be careful not to damage the
harness. |
| • |
Be careful not to pull the
harness
forcibly. | |
|
| 7. |
Remove the O-ring (B) and the gasket (C)
from the wire (A).
|
| 1. |
After coating a new gasket (C) with ATF,
install it to the wire (A).
|
| 2. |
Install a new O-ring (B) to the
wire.
O-ring
size: inner dia.-27.3mm,
thickness-2.4mm
|
|
Do not coat ATF to the
O-ring. | |
| 3. |
Install the wire (A) to the transaxle
case.
| • |
Be careful not to apply too much
force to the wire. |
| • |
Be careful not to damage the T/M
wire. | |
|
Install the wire to the transaxle case
by engaging its claw. |
|
| 4. |
Install a new wire lock plate
(B). |
| 5. |
Install the transaxle side cover and the
valve body assembly. (refer to Solenoid valve's
Installation)
|
Be careful not to drop the valve body
assembly. | |
| 6. |
Coat the new O-rings with ATF, and install
it to the oil cooler tubes (A). Install the oil cooler tubes with
the 2 bolts.
O-ring
size: inner dia.-11.6mm,
thickness-2.35mm
Tightening
torque :
20-30 Nm (2.0-3.0kgf.m, 14.5-21.7
lb-ft)
Bolt size
(8) :
M8x1.25x20mm
|
|
| 7. |
Connect the oil cooler hoses from the
tubes. |
| 8. |
Install the drain plug (A) and the gasket by
using a hexagon wrench (17mm).
Tightening
torque :
35-61 Nm (3.5-6.1kgf.m, 25.3-44.1
lb-ft)
|
Install the TCU. (refer to TCM's
Installation)
Tightening
torque :
20-30 Nm (2.0-3.0kgf.m, 14.5-21.7
lb-ft)
Bolt size
(8) :
M8x1.25x20mm
| |
| 9. |
Refill the ATF. (refer to Procedure of Oil
level adjusting) |
| 10. |
Perform N position learning. (refer to
Troubleshooting's 'How to perform N position
learning') |
| 11. |
Perform initial learning. (refer to
Troubleshooting's 'How to perform initial
learning') | |
