Please pay attention
to the following when installing or removing transaxle.
● Handling with care
for electronic parts
| 1. |
When replacing an electronic part, be sure
to switch the ignition off and disconnect the battery from the
negative (-) terminal before servicing the
system. |
| 2. |
Do not jar electronic parts. If a part is
dropped or shocked, replace it with a new
one. |
● Prevention of
foreign substances
| 1. |
Be sure to remove dust, sand, etc.
thoroughly from A/T when removing an associated part from
it. |
| 2. |
Protect the removed part from dust by
covering it with a plastic bag,
etc. |
| 3. |
Perform the service procedures using plastic
gloves, and do not use work gloves or a
rag. |
● Prevention of part
damage
| 1. |
When separating an attached surface of the
case, etc., tap with a plastic hammer to take the parts apart. [DO
NOT PRY PARTS OFF WITH A SCREWDRIVER,
ETC.] |
| 2. |
Do not pull out the valve, etc. with
excessive force. |
● Cleaning of
parts
| 1. |
All parts have to be thoroughly cleaned,
dried by blown air and coated with the specified
oil. |
| 2. |
Do not clean aluminum parts and rubber parts
with alkaline chemicals. |
| 3. |
Do not clean rubber parts with washing oil
(white gasoline). |
● Caution for handling
ATF
| 1. |
Do not drain ATF while it is still hot.
(Service the system after it cools
down.). |
| 2. |
Be sure to use JWS-3309 (T-IV) type
ATF. |
