FRONT
DOOR LOCK ACTUATOR
| 1. |
Remove the front door trim.
(Refer to the Body group - Front
door) |
| 2. |
Remove the front door module.
(Refer to the Body group - Front
door). |
| 3. |
Disconnect the connectors (6P) from the
actuator.
|
| 4. |
Check actuator operation by connecting power
and ground according to the table. To prevent damage to the
actuator, apply battery voltage only momentarily.
|
REAR
DOOR LOCK ACTUATOR
| 1. |
Remove the rear door trim.
(Refer to the Body group - Rear
door) |
| 2. |
Remove the rear door module.
(Refer to the Body group - Rear
door) |
| 3. |
Disconnect the connectors from the
actuator.
|
| 4. |
Check actuator operation by connecting power
and ground according to the table. To prevent damage to the
actuator, apply battery voltage only momentarily.
|
TAILGATE
LOCK ACTUATOR INSPECTION
| 1. |
Remove the tailgate trim. (Refer to the Body
group - tailgate) |
| 2. |
Disconnect the 4P connector from the
actuator.
|
| 3. |
Check actuator operation by connecting power
and ground according to the table. To prevent damage to the
actuator, apply battery voltage only momentarily.
|
FRONT
DOOR LOCK SWITCH
| 1. |
Remove the front door trim.
(Refer to the Body group - Front
door) |
| 2. |
Remove the front door module.
(Refer to the Body group - Front
door). |
| 3. |
Disconnect the connectors from the
actuator.
|
| 4. |
Check for continuity between the terminals
in each switch position when inserting the key into the door
according to the table.
|
REAR
DOOR LOCK SWITCH
| 1. |
Remove the rear door trim.
(Refer to the Body group - Rear
door) |
| 2. |
Remove the rear door module.
(Refer to the Body group - Rear
door) |
| 3. |
Disconnect the connectors from the
actuator.
|
| 4. |
Check for continuity between the terminals
in each switch position according to the table.
|
TAILGATE
SWITCH
| 1. |
Remove the tailgate trim. (Refer to the Body
group - Tailgate) |
| 2. |
Disconnect the 4P connector from the
actuator.
|
| 3. |
Check for continuity between the terminals
in each switch position according to the table.
|
DOOR
SWITCH
Remove the door switch
and check for continuity between the terminals.
HOOD
SWITCH
| 1. |
Remove the hood latch.
(Refer to the Body group -
Hood) |
| 2. |
Disconnect the connector(A) from the hood
switch.
|
| 3. |
Check for continuity between the terminals
and ground according to the table.
|
KEY
WARNING SWITCH
| 1. |
Remove the crash pad lower panel. (Refer to
Body group-Crash pad) |
| 2. |
Disconnect the 6P connector from the key
warning switch.
|
| 3. |
Check for continuity between the terminals
in each position according to the table.
|
