| 1. |
Remove the front bumper. (Refer to the Body
group - front bumper). |
| 2. |
Remove the bolt and disconnect the horn
connector, then remove the high pitch horn (A) and low pitch horn
(B).
|
| 1. |
Connect the horn connector, then reassemble
the high pitch horn and low pitch
horn. |
| 2. |
Reassemble the front
bumper. |
Test the horn by
connecting battery voltage to the 1 terminal and ground the 2
terminal.
The horn should make a
sound. If the horn fails to make a sound, replace it.
HORN
RELAY INSPECTION
| 1. |
Remove the horn relay (A) from the engine
room relay box. |
| 2. |
There should be continuity between the No.30
and No.87 terminals when power and ground are connected to the No.85
and No.86 terminals. |
| 3. |
There should be no continuity between the
No.30 and No.87 terminals when power is disconnected.
|
| 1. |
Operate the horn, and adjust the tone to a
suitable level by turning the adjusting screw.
|
After adjustment, apply a small amount
of paint around the screw head to keep it from
loosening. |
|
