Rear Side Impact
Sensor(RSIS) is located in both side of C pillar detects broad
collision.
When SIS delivers
collision signal to SRSCM, SRSCM checks if safing sensor located in SRSCM
detects collusion. and if both SIS and safing sensor detects collision
simultaneously, SRSCM operates side air bag.
The SRSCM sets DTC
B1412/B1413 if there is any error in communication between RDSIS/RPSIS and
SRSCM.
The SRSCM sets DTC
B1418/B1419 if there is any fault in RDSIS/RPSIS circuit.
Item
|
Detecting
Condition
|
Possible
cause
|
DTC Strategy
|
| •
|
Check current(PWM
type) | |
|
Enable Conditions
|
|
Diagnostic
Time
|
Qualification
|
B1412
B1413
|
|
B1418
B1419
|
|
De-Qualification
|
B1412
B1413
|
|
B1418
B1419
|
|
| 1. |
Ignition "OFF", connect
scantool. |
| 2. |
Ignition "ON"& Engine "OFF", select
"Diagnostic Trouble Codes(DTC)"
mode. |
| 3. |
Monitor diagnostic trouble code and present
of trouble code. |
| 4. |
Using a scantool, clear the
DTC.
|
| 5. |
Is DTC present problem ?
▶ Go to "W/Harness Inspection"
procedure.
▶ Displaying nothing(no DTC) or DTC with
label "H"(historical) shows that Fault is intermittent caused by
poor contact in the part's and/or SRSCM connector or was repaired
and SRSCM memory was not cleared.
Thoroughly check connectors for looseness,
poor connection, bending, corrosion, contamination, deterioration,
or damage.
▶ Repair or replace as necessary and then go
to "Verification of Vehicle Repair"
procedure. |
| Terminal and Connector
Inspection |
| 1. |
Many malfunctions in the electrical system
are caused by poor harness and terminals.
Faults can also be caused by interference
from other electrical systems, and mechanical or chemical
damage. |
| 2. |
Thoroughly check connectors for looseness,
poor connection, bending, corrosion, contamination, deterioration,
or damage. |
| 3. |
Has a problem been found?
▶ Repair as necessary and then go to
"Verification of Vehicle Repair" procedure.
▶ Go to "Component Inspection"
procedure. |
| 1. |
Ignition "ON" & Engine "OFF" and Using a
scantool, clear the DTC. |
| 3. |
Disconnect the battery (-) terminal cable
from the battery, and wait at least one
minutes. |
| 4. |
Disconnect RSIS
connector. |
| 5. |
Substitute the RSIS and check for proper
operation. |
| 6. |
Is DTC present problem ?
▶ Substitute a known-good SRSCM, and check
for proper operation.
If the problem is corrected, replace SRSCM
and then go to "Verification of Vehicle Repair"
procedure.
▶ Substitute the SRS main harness and check
for proper operation.
If the problem is corrected, replace SRS
main harness and then go to "Verification of Vehicle Repair"
procedure.
▶ Substitute a known-good RSIS, and check
for proper operation.
If the problem is corrected, replace SRSCM
and then go to "Verification of Vehicle Repair"
procedure. |
| Verification of Vehicle
Repair |
Refer to the
DESCRIPTION in this TROUBLESHOOTING
section.
