POWER TAILGATE INITIALIZATION
POWER TAILGATE SYSTEM RESET
Certain conditions may
require that the PTG system be reset.
| 1. |
Remove the MEMORY fuse that provides logic
power to the PTGM. |
| 2. |
Replace fuse after few seconds. Initialize the
PTGM. |
INITIALIZATION PROCEDURE
The Power Tailgate
system initialization must start from the full closed or latched position.
The Tailgate must be powered Open once to fully initialize the system
(Obstacle detection shall be active during Tailgate
initialization).
| 1. |
Manually close and latch the
Tailgate. |
| 2. |
Power the Tailgate open using the Open/Close
switch, outside handle or the remote
control. |
ALTERNATE METHOD
| 1. |
Remove the black connector (J2) from the
PTGM. |
| 2. |
Wait a couple seconds. Replace connector.
Initialize PTGM.
| -
|
The PTG system initialization must
start from the primary or secondary latched
position. |
| -
|
Obstacle detection shall be active
during system
initialization. | | |
